this post was submitted on 01 Nov 2023
1418 points (100.0% liked)
196
16552 readers
1623 users here now
Be sure to follow the rule before you head out.
Rule: You must post before you leave.
founded 1 year ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
Just do a midprint filament swap... Looking at getting into TPU at the moment, it might actually be a fun way to have my kid hand something short in. 3 layers of white, 0.12mm per layer, swap to black and print 3 layers more. I'd be concerned about stringing and delamination. But it's pretty close to the heated bed, so mostly stringing. Fuckit we're going to try!
Your now going to do this and report back right?
Actually, I was going to yesterday. But I will try to get to it this weekend. Am becoming a bit worried about warping though...
Engineering Method my friend