this post was submitted on 05 Feb 2025
697 points (99.3% liked)
People Twitter
5736 readers
1757 users here now
People tweeting stuff. We allow tweets from anyone.
RULES:
- Mark NSFW content.
- No doxxing people.
- Must be a pic of the tweet or similar. No direct links to the tweet.
- No bullying or international politcs
- Be excellent to each other.
- Provide an archived link to the tweet (or similar) being shown if it's a major figure or a politician.
founded 2 years ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
Frankly, it's probably not even that much. They probably used a bolt action and really light powder loads. I'd say maybe it's a .22 but the dents look big for that.
Edit: Someone else posted this a JerryRigEverything video- it apparently stops .22 and 9mm. I'm pretty surprised.
Looking it up, the doors are 1.8mm steel. At a 90 degree angle that's enough to stop underpowered 9mm rounds reliably. It will stop most normal rounds fired at it, and especially start letting a lot through in areas with repeated stress. The second you hot load a round, use a heavy projectile or any kind of round with more potential than standard FMJ it's all going through.
And that has to be the right kind of steel too. Which is more expensive. So yeah I'm pretty sure they used underpowered rounds at the very least to create this visual.
Checked brandon herrera. Seems like its bullet resistant and can handle non hot or ap loads from 9mm and below pistols and that's it. Still hard to believe since there's all info is from big tech platforms and big youtubers who are all famous for their jorunalistic integrity.
Pellet gun dude
Good enough to run over all the liberal protestors!