this post was submitted on 17 Dec 2024
260 points (99.6% liked)

Star Trek Social Club

10667 readers
219 users here now

r/startrek: The Next Generation

Star Trek news and discussion. No slash fic...

Maybe a little slash fic.


New to Star Trek and wondering where to start?


Rules

1 Be constructiveAll posts/comments must be thoughtful and balanced.


2 Be welcomingIt is important that everyone from newbies to OG Trekkers feel welcome, no matter their gender, sexual orientation, religion or race.


3 Be truthfulAll posts/comments must be factually accurate and verifiable. We are not a place for gossip, rumors, or manipulative or misleading content.


4 Be niceIf a polite way cannot be found to phrase what it is you want to say, don't say anything at all. Insulting or disparaging remarks about any human being are expressly not allowed.


5 SpoilersUtilize the spoiler system for any and all spoilers relating to the most recently-aired episode. There is no formal spoiler protection for episodes/films after they have been available for approximately one week.


6 Keep on-topicAll busmittions must be directly about the Star Trek franchise (the shows, movies, books, etc.). Off-topic discussions are welcome at c/Quarks.


7 MetaQuestions and concerns about moderator actions should be brought forward via DM.


Upcoming Episodes

Date Episode Title
11-28 LD 5x07 "Fully Dilated"
12-05 LD 5x08 "Upper Decks"
12-12 LD 5x09 "Fissure Quest"
12-19 LD 5x10 "The New Next Generation"
01-24 Film "Section 31"

Episode Discussion Archive


In Production

Strange New Worlds (TBA)

Section 31 (2025-01-24)

Starfleet Academy (TBA)


In Development

Untitled theatrical film

Untitled comedy series


Wondering where to stream a series? Check here.

Allied Discord Server


founded 2 years ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
[–] princessnorah@lemmy.blahaj.zone 1 points 10 hours ago (1 children)

For fun I looked up how I’d have to mount a front plate and it’s just gross. I’d have to drill holes into the front...

Wow no kidding.

[–] Graphy@lemmy.world 1 points 9 hours ago (1 children)

Nice to see you really wanted to keep this post going lol

Almost as if there’s a difference between

An assembly line making perfectly centered holes into a part that they’ve yet to finish painting and detailing

versus

my ass crouching down and praying I can get four clean pilot holes in and by some miracle the paint not start flaking

Not to mention what if I put the plate slightly too high and it catches more wind and starts making some annoying ass whistling

[–] Cort@lemmy.world 1 points 5 hours ago

Lol my concern would be it getting enough wind behind it and ripping it right off the bumper.