Thank you, I will give that a try.
Thanks, maybe it was just tangled filament ๐ค, but I will do a cold pull anyways.
I was printing PLA, it looks ok up to a certain height (although it was warping slightly), but then it becomes ugly. I will do a test print of the same height, butaybe you already have an idea.
Depends on the PKM tool I would say. I used Joplin with its internal sync with Nextcloud without problems in the past. Then I switched to Logseq which does not have an integrated sync so I had to rely on the respective clients. On Windows and Linux this works fine with Nextcloud, but automatic sync on phones (at least Android) sucks. So I switched to Syncthing for this purpose as the phone sync is more reliable now. I have however a small "server" (RPi or similar is sufficient) running 24/7 to keep the notes in sync even if my devices would not be online in parallel.
Maybe it was just tangled filament?๐ค
White my test print from afterwards (after unspooling the last two meters from my first self rolled spool ๐ ), grey a print from a few days ago.