Technology

34819 readers

19 users here now

This is the official technology community of Lemmy.ml for all news related to creation and use of technology, and to facilitate civil, meaningful discussion around it.

Ask in DM before posting product reviews or ads. All such posts otherwise are subject to removal.

Rules:

1: All Lemmy rules apply

2: Do not post low effort posts

3: NEVER post naziped*gore stuff

4: Always post article URLs or their archived version URLs as sources, NOT screenshots. Help the blind users.

5: personal rants of Big Tech CEOs like Elon Musk are unwelcome (does not include posts about their companies affecting wide range of people)

6: no advertisement posts unless verified as legitimate and non-exploitative/non-consumerist

7: crypto related posts, unless essential, are disallowed

founded 5 years ago

MODERATORS

MinutePhrase@lemmy.ml

A Surprise Hardware Bug in Raspberry Pi's RP2350 Leads to Unexpected Pull-Down Behavior (www.hackster.io)

submitted 2 months ago by geneva_convenience@lemmy.ml to c/technology@lemmy.ml

1 comments fedilink hide all child comments

Raspberry Pi has confirmed a bug in the new RP2350 microcontroller family, which causes pins to freeze outputting 2.15V when configured as inputs using the internal pull-down resistors — tied, it seems, to changes made by a vendor to an off-the-shelf fault tolerant pad IP block.

"[I] found a silicon bug," Dangerous Prototypes' Ian Lesnet explains of the issue, which has been confirmed as an erratum in Raspberry Pi's official documentation for the newly-launched dual-architecture RP2350 microcontroller family. "When a GPIO [General-Purpose Input/Output] pin is an input with the pull-down resistor enabled, it acts like a bus hold. We use the pull-down on the button, which connects to 3.3V when pressed. During the self-test pressing the button works, but then it never goes low again, it sits at 2.15V…"

top 1 comments

sorted by: hot top controversial new old

[–] deegeese@sopuli.xyz 7 points 2 months ago

So the conclusion is basically “pull down resistors don’t work because vendor screwup”?

Any plans for a new HW revision?