Star Trek Social Club
r/startrek: The Next Generation
Star Trek news and discussion. No slash fic...
Maybe a little slash fic.
New to Star Trek and wondering where to start?
Rules
1 Be constructive
All posts/comments must be thoughtful and balanced.
2 Be welcoming
It is important that everyone from newbies to OG Trekkers feel welcome, no matter their gender, sexual orientation, religion or race.
3 Be truthful
All posts/comments must be factually accurate and verifiable. We are not a place for gossip, rumors, or manipulative or misleading content.
4 Be nice
If a polite way cannot be found to phrase what it is you want to say, don't say anything at all. Insulting or disparaging remarks about any human being are expressly not allowed.
5 Spoilers
Utilize the spoiler system for any and all spoilers relating to the most recently-aired episode. There is no formal spoiler protection for episodes/films after they have been available for approximately one week.
6 Keep on-topic
All busmittions must be directly about the Star Trek franchise (the shows, movies, books, etc.). Off-topic discussions are welcome at c/Quarks.
7 Meta
Questions and concerns about moderator actions should be brought forward via DM.
Upcoming Episodes
| Date | Episode | Title |
|---|---|---|
| 11-28 | LD 5x07 | "Fully Dilated" |
| 12-05 | LD 5x08 | "Upper Decks" |
| 12-12 | LD 5x09 | "Fissure Quest" |
| 12-19 | LD 5x10 | "The New Next Generation" |
| 01-24 | Film | "Section 31" |
In Production
Strange New Worlds (TBA)
Section 31 (2025-01-24)
Starfleet Academy (TBA)
In Development
Untitled comedy series
Wondering where to stream a series? Check here.
view the rest of the comments
reversing polarity is the solution to all of your woes.
When switching from flux core wire to regular wire with shielding gas on my welder it calls to reverse the polarity of the electricity to the welding gun. You have to open it up and swap two wires around. It always cracks me up inside when I'm telling people I had to reverse the polarity of the welder to get a better weld.
A few months ago I bought some old (quite good) speakers. My first step, of course, was to use a calibrated mic to measure them. One measured way better than the other. Took them apart and realized at some point someone had connected wires incorrectly on one of the tweeters causing it to be out of phase. Do you know what this means?
I REVERSED THE POLARITY AND FIXED MY AUDIO PROBLEM. That day I became a Starfleet Engineer.
That, or inaprovaline
I thought it was an inverse tachyon beam from the main deflector array