this post was submitted on 02 Jun 2024
795 points (96.4% liked)
Memes
8352 readers
407 users here now
Post memes here.
A meme is an idea, behavior, or style that spreads by means of imitation from person to person within a culture and often carries symbolic meaning representing a particular phenomenon or theme.
An Internet meme or meme, is a cultural item that is spread via the Internet, often through social media platforms. The name is by the concept of memes proposed by Richard Dawkins in 1972. Internet memes can take various forms, such as images, videos, GIFs, and various other viral sensations.
- Wait at least 2 months before reposting
- No explicitly political content (about political figures, political events, elections and so on), !politicalmemes@lemmy.ca can be better place for that
- Use NSFW marking accordingly
Laittakaa meemejä tänne.
- Odota ainakin 2 kuukautta ennen meemin postaamista uudelleen
- Ei selkeän poliittista sisältöä (poliitikoista, poliittisista tapahtumista, vaaleista jne) parempi paikka esim. !politicalmemes@lemmy.ca
- Merkitse K18-sisältö tarpeen mukaan
founded 2 years ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
Don't know what car you're driving but I think you're just using the wrong size wrench/Allen key
My last car was a 2012 ford fiesta. The lug nuts are 19mm. The caliper bolts were 10mm and the slide bolts were 3/8.
The car before that was a 2001 cavalier. Not only did it have metric and standard bolts but the slide bolts were fuckin Allen heads.
Like literally why?
Probably because they were made by American car manufacturers and couldn't make a logical or consistent design decision if their lives depended on it.
Like I'm not even an engineer and I'm just screaming about the dumbest decisions made by people who make more in a week than I make in a year 😭
The last one I ran into is that the Windshield Washer Fluid Reservoir in a Chevy Bolt is about 1/4 cup smaller than a standard 1 gallon jug of fluid. You could have expanded the diameter of the fill tube by less than 1/8 of an inch and fit that remaining 1/4 cup of fluid in there.
Yeah, but the difference is that they made it so you need an extra socket or an alan wrench. I think you'd have made dumb decisions that were a little bit more deadly.
It's usually cost. They have tooling to produce components that have probably been around decades. The cost of retooling just to change the fastener sizes may not be economically viable. Eventually these legacy components will be phased out and it will be 100% metric.