Star Trek
r/startrek: The Next Generation
Star Trek news and discussion. No slash fic...
Maybe a little slash fic.
New to Star Trek and wondering where to start?
Rules
1 Be constructive
All posts/comments must be thoughtful and balanced.
2 Be welcoming
It is important that everyone from newbies to OG Trekkers feel welcome, no matter their gender, sexual orientation, religion or race.
3 Be truthful
All posts/comments must be factually accurate and verifiable. We are not a place for gossip, rumors, or manipulative or misleading content.
4 Be nice
If a polite way cannot be found to phrase what it is you want to say, don't say anything at all. Insulting or disparaging remarks about any human being are expressly not allowed.
5 Spoilers
Utilize the spoiler system for any and all spoilers relating to the most recently-aired episodes, as well as previews for upcoming episodes. There is no formal spoiler protection for episodes/films after they have been available for approximately one week.
6 Keep on-topic
All submissions must be directly about the Star Trek franchise (the shows, movies, books etc.). Off-topic discussions are welcome at c/quarks.
7 Meta
Questions and concerns about moderator actions should be brought forward via DM.
Upcoming Episodes
| Date | Episode | Title |
|---|---|---|
| 11-28 | LD 5x07 | "Fully Dilated" |
| 12-05 | LD 5x08 | "Upper Decks" |
| 12-12 | LD 5x09 | "Fissue Quest" |
| 12-19 | LD 5x10 | "The New Next Generation" |
| 01-24 | Film | "Section 31" |
In Production
Strange New Worlds (2025)
Section 31 (2025-01-24)
Starfleet Academy (TBA)
In Development
Untitled comedy series
Wondering where to stream a series? Check here.
view the rest of the comments
I recently had a pretty horrible experience with an AMT Enterprise-D. Bad plastic quality, giant sprue marks all over the place (including on panel lines), and terrible fit. It was like a blast to the past of what model building was during the 1990s, before modern injection molding technology.
Makes sense and good to know.
Some of the older Klingon model designs have been updated as they are rereleased. I can see that the Enterprise D would need that too.
Definitely the case that injection-moulded plastic models and miniatures have come up significantly in quality and down in cost in the past two decades as the technology has changed.
It would be important to know if these rereleases is an updated reissue or not. The proprietor of this shop seems to be in the k is on these points. It would be worth messaging him to ask if people are interested.
By the way, from the information he seems to have got at the con where the upcoming SNW Enterprise was promoted, it sounds like AMP is reworking the model design from its limited issue Discovery Enterprise to match the refit between Disco and SNW.