this post was submitted on 02 Dec 2023
11 points (92.3% liked)

Home Improvement

9030 readers
1 users here now

Home Improvement

founded 1 year ago
MODERATORS
nichos@lemmy.world
nieceandtows@lemmy.world
Confound4082@lemmy.ml
nieceandtows@programming.dev
11
How do I fix this? Is it the spring or something else? (imgur.com)
submitted 11 months ago* (last edited 11 months ago) by kjpctech@lemm.ee to c/homeimprovement@lemmy.world
4 comments fedilink hide all child comments
 

See title. Is it the spring lifting one side off the ground or is it something else like the cable on that side? Thanks for any advice!

Edit: From what I can tell the door and the floor are both slightly off level in opposite directions. I also just replaced the bottom seal in an attempt to fix this.

you are viewing a single comment's thread
view the rest of the comments
[–] Grumpydaddy@lemmy.world 8 points 11 months ago* (last edited 11 months ago)

Looks like the concrete falls off on the right.

The gasket at the bottom of your overhead compresses to help create a seal along an uneven surface, but it can only do so much. Your gap may be too large to seal before the door bottoms out completely on the left. That said, there is adjustments that set where the door comes to a stop when closing, check your manual and see if the overhead can lower further.