3DPrinting is a place where makers of all skill levels and walks of life can learn about and discuss 3D printing and development of 3D printed parts and devices.
The r/functionalprint community is now located at: !functionalprint@kbin.social or !functionalprint@fedia.io
There are CAD communities available at: !cad@lemmy.world or !freecad@lemmy.ml
No bigotry - including racism, sexism, ableism, homophobia, transphobia, or xenophobia. Code of Conduct.
Be respectful, especially when disagreeing. Everyone should feel welcome here.
No porn (NSFW prints are acceptable but must be marked NSFW)
No Ads / Spamming / Guerrilla Marketing
Do not create links to reddit
If you see an issue please flag it
No guns
No injury gore posts
If you need an easy way to host pictures, https://catbox.moe may be an option. Be ethical about what you post and donate if you are able or use this a lot. It is just an individual hosting content, not a company. The image embedding syntax for Lemmy is 
Moderation policy: Light, mostly invisible
Hi, I have printed a small holder for a Bowden tube to print from my filament dryer outside of the enclosure, but the filament coming out of the tube is tensioned and I don’t know if it will cause problems later. Is this fine to keep or how can I fix this? This i a Ender 3 V3 SE btw.
It might. Depending on how much tension there is. Too much and it will cause the filament to slip in the extruder causing under extrusion. If you are not seeing signs of under extrusion then you are fine for now - but that might change if you change filament or anything else. I would try to lower how much tension the filament is under to avoid problems in the future. Otherwise it would be something to keep in mind if you do start seeing signs of under extrusion.
But how do I lower the tension? I think its just the friction in the tube.
It could be a tight bend in the line somewhere - make sure there are no tight bends. Otherwise if it is the tube then get a thicker tube.